Description:

*ONLY COMPATIBLE WITH JP40 LITHIUM BATTERY* THE IMPORTANCE OF THE REMOTE DISPLAY: In demanding conditions of high amperage discharge, fast charging, and extended highamperage discharge, it is important to monitor the battery to keep the battery from beingdamaged. If the battery is discharged below the minimum voltage the battery will be damaged,and such damage will cause the battery to lose performance and/or cause a dangerousoperating condition which could result in personal injury, equipment damage, or death. Thesame is true if the battery is allowed to over heat, or be over charged. This remote tool is a wayto monitor the batterys operation within the specified parameters without a putting restrictiveBattery Management System (BMS) that reduces the amount of control the user has over thebatterys operation. As with all tools, it is only as effective as the user. If the warnings are notheeded, or ignored the battery may become damaged, and this will void the warranty. CONNECTION METHOD The remote monitor has 2 plugs, a Phone jack, and an 2 pin port. The phone jack is connectedfrom the remote monitor and the plug labeled remote on the face of the battery.The 2 pin plug on the remote monitor can be used to connect the monitor to a 12V powersupply, (Example: the cars ignition system.) as a alternate power supply to keep the remotemonitor from using the batterys power. INSTRUCTION FOR USE:Connect the battery with the remote monitor using the supplied cable.To Change Voltage/Capacity DisplayThe default mode of the voltage/capacity display is the batterys voltage. If the buttonmarked Voltage/Capacity is pressed, the display will change to the show the batteryscapacity in percentage of remaining charge. If the button is pressed again, it will return tothe default display. To Change The Temperature Display: The default mode of the temperature display is in Fahrenheit (Fo). If the button markedTemperature is pressed, the display will change to the unit of Celsius (Co). If the button ispressed again, it will return to the default display.REMOTE The JP40 Remote Display ships in the default setting that allows for plug and play use with theJP40 battery. Initial programming is not required when you purchase this remote for use withJP40. However, this remote is also designed to be used universally with AGM, Li-Po, LTO andother LFP type batteries in many configurations. Although the programming details shownbelow are accessible, they are only applicable to the universal remote model, which includesthe voltage and temperature sending unit that can be used external to any battery. This willnot allow for the accurate internal temperature readings you get from your JP40 Battery sincethe sending unit is already inside the battery. The programming instructions are providedbelow for knowledge about these functions in case the menu is accessed accidentally, and thesettings need to be corrected for accurate functionality of the remote display.Press and hold the Menu button for six (6) seconds to access the program mode. The displaywill flash indicating it is in program mode. If no buttons are pressed within six (6) seconds theunit will automatically exit program mode. To set battery type, enter program mode. Use the Buttons marked with the up and down arrowsto select the correct battery type. The battery types available to select are as follows:L - Lithium Ion Batteries (Li-ion, Li-po) [ Cell Voltage is 3.6V-3.8V ]F - Lithium Iron Phosphate Batteries (LFP) [ Cell Voltage is 3.2V ]P - Lead Acid Batteries (AGM) [ Battery Voltage is 12V ]t - Lithium Titanate Oxide Batteries (LTO) [ Cell Voltage 2.4V ] Once the battery type is selected, press the Menu button again to set the number of cells inseries. The display will once again flash,Set the number of cells in series using the up and down arrows as before.EXAMPLE: 3S - is set to 034S -